Specification
Stable cast base
Test up to 6 ATM
Material: Aluminum
Capacity: 2 watches
Maximum test height::72mm
External Pressure interface:6N
Cylinder maximum pressure:10bar
Cylinder external diameter::80mm
Cylinder inside diameter::70mm
Cylinder height::140mm
How to use
1.Fill the cylinder with water up to the indicated level.
It is preferable to use distilled water in order to avoid limy deposit.
2.Hang the watch on the hook.
3.Replace the lid and screw it tight by means of the 2 nuts
4.Using the lever raise the pressure to 3 atmospheres (requirement
according to the official standard of the Swiss watch industry), and
wait for 3 minutes to allow air to enter the watch
5.Immerse the watch and immediately allow the air to escape by pressing
the knob While the pressure is falling, observe the watch:if little air bubbles
escape from the case, it is obvious that sealing is bad at the point of escape.
In this case, lift the watch out of the water.
Package include:
1 pc water waterproof tester